Discontinued
modules
Marbles
Open-source

Firmware hacking

Marbles’ source code is available under the MIT licence.

The code (along with the hardware description files) can be found in the marbles directory in our Eurorack modules git repository.

After having cloned the repository, don’t forget to run git submodule init && git submodule update to make sure the sub-projects referenced in the code are also pulled.

Toolchain

If you don’t mind installing Vagrant and VirtualBox a cozy environment for firmware hacking is available.

If you want to set up your own environment to build Marbles’ code, an ARM EABI toolchain must be installed. Because of tight CPU and code size limits, we recommend you to use the same compiler version as we do: 4.8-2013-q4-major. Various pre-compiled binaries and source packages are available here.

The path to the toolchain binaries must be specified in the TOOLCHAIN_PATH variable in marbles/makefile.

To build the bootloader, use the following command:

make -f marbles/bootloader/makefile hex

To build the code, use the following command:

make -f marbles/makefile

If you modify lookup tables and want the big resources.cc file to be regenerated:

touch marbles/resources/resources.py && make -f marbles/makefile resources

Firmware programming

The recommended solution for firmware programming is to use a ST Discovery board. Connect the 4 SWD lines of the board to the 4 programming lines of Marbles (RESET, SWDIO, SWCLK and GND).

Make sure that the programming interface (PGM_INTERFACE variable) is set to stlink-v2 in stmlib/programming.inc.

Upload the firmware with:

make -f marbles/makefile upload

Note that this will destroy the factory calibration data.

DAC Calibration

In a DIY situation, the most direct way of calibrating the module is to initialize the structure storing the calibration data to the correct values, deduced by measurement. Modify Settings::Init() to include the following lines:

persistent_data_.calibration_data.dac_offset[0] = 32768.0f /* FIXME */;
persistent_data_.calibration_data.dac_scale[0] = -6212.8f /* FIXME */;
// SNIP SNIP
persistent_data_.calibration_data.dac_offset[3] = 32768.0f /* FIXME */;
persistent_data_.calibration_data.dac_scale[3] = -6212.8f /* FIXME */;

With a factory-made module, it is recommended to backup and restore the data originally written in the Flash memory of the module in range 0x08004000:0x08008000 (factory calibration data).

Hardware hacking

Schematics, board layout, BOM and panel drawings can be found in the marbles directory in our Eurorack modules git repository.

All these hardware description files are released under a cc-by-sa-3.0 license.