Warps – Open source
Warps is open-source. The code and hardware files can be found in the warps directory in our Eurorack modules git repository.
After having cloned the repository, don’t forget to run
git submodule init && git submodule update to make sure the sub-projects referenced in the code are also pulled.
If you want to set up your own environment to build Warps’ code, an ARM EABI toolchain must be installed. Because of tight CPU and code size limits, we recommend you to use the same compiler version as we do: 4.8-2013-q4-major. Various pre-compiled binaries and source packages are available here.
The path to the toolchain binaries must be specified in the
TOOLCHAIN_PATH variable in
To build the code, use the following command:
make -f warps/makefile
If you modify lookup tables and want the big
resources.cc file to be regenerated:
touch warps/resources/resources.py && make -f warps/makefile resources
The bootloader .hex file, needed for programming, can be built with:
make -f warps/bootloader/makefile hex
Updating the firmware
A first solution is to simply use the firmware update procedure. A .wav file for firmware upgrade can be generated with:
make -f warps/makefile wav
The firmware can then be loaded into the module using the procedure described in the manual.
Past this point, we assume you know what you are doing and we are not responsible for any damage to your module!
Another solution is to use the built-in serial bootloader of the STM32F. Connect a FTDI dongle with a 3.3V output level (such as this) to the 6 pin connector at the back of the module. If necessary, edit the serial port special file corresponding to the FTDI dongle in the
PGM_SERIAL_PORT variable in
stmlib/makefile.inc. GND must match GND, TX must match RX and vice-versa.
Hold the RESET switch on the side of the module. Press the SYSBOOT switch next to it, and release RESET. All LEDs are off (the module is in bootloader limbo…)
Upload the firmware with:
make -f warps/makefile upload_combo_serial
The last – and recommended – solution for firmware updating is to use a JTAG interface and openOCD. We recommend Olimex’ ARM-USB-OCD-H devices. Their older ARM-USB-OCD product is also known to work – and is in the fact used for factory programming. Configuration data for both are listed in
stmlib/programming/jtag/interface.cfg – uncomment the one which is not needed.
An adapter must also be purchased for the mini-JTAG connector used by Warps.
Upload the firmware with:
make -f warps/makefile upload_combo_jtag
Schematics, board layout and panel files can be found in the
warps/hardware_design directory of the github repository.
The hardware description files are released under a cc-by-sa-3.0 license. The source code is released under the MIT license.
Olivier Gillet, Mutable instruments SARL 2011-2017. Except where otherwise noted, content on this site is licensed under a cc-by-sa 3.0 license.